Canon 1000 Service Manual page 184

3. OPERATION AND TIMING
c. Lifter Operation
Figure 3-610 shows an outline of multifeeder lifter operation.
When the Start key is pressed, the multifeeder lifter motor (M1) rotates clockwise to raise the multifeeder
lifter by the lifter plate until the multifeeder lifter sensor (upper: PS2) turns ON.
This ascending movement of the lifter puts the paper on the multifeeder tray in contact with the
multifeeder pick-up roller, making it ready for pick-up.
The multifeeder motor rotates in reverse at the following timing so that the multifeeder lifter lowers until
the multifeeder lifter sensor (lower: PS3) turns ON.
• When paper is absent (for supply of paper).
• When a jam has occurred (for jam removal).
• When copying ends (for supply of paper or making changes).
If the multifeeder lifter sensor (PS2, PS3) does not turn ON within a specific period of time, 'E040' will be
indicated on the control panel.
J2209B J2207B
-10,-11 -5
Multifeeder lifter sensor
(upper: PS2)
M1
Multifeeder
lifter motor
3-140
COPYRIGHT © 2001 CANON INC.
DC controller PCB
Multifeeder relay PCB
Sensor lever
Multifeeder
pick-up rollers
Front
Figure 3-610
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Paper
Slide guide
Sensor lever
Lifter
Multifeeder lifter
J2207B
-13
Multifeeder lifter
sensor (lower: PS3)