English - Black & Decker GW200 User Manual

Maintenance and storage
•
Store your product in a dry place when
not in use, out of the reach of children.
•
Do not use solvents or cleaning fluids to
clean your product - use a blunt
scraper to remove grass and dirt.
Always disconnect from the electrical
supply before cleaning.
•
Do not operate your product if any
parts are defective; discard all defective
parts and fit new parts before use.
•
Keep all nuts, bolts and screws tight to
be sure your product is in a safe
working condition.
•
Use only Black & Decker recommended
replacement parts and accessories.
•
Replacement fans are available from a
Black & Decker service agent.
Warning! If the supply cord is damaged,
it must be replaced by a special cord or
assembly available from an authorised
repair agent (Black & Decker part number:
372832-01 - UK only and part number:
370017-04 - Australia and New Zealand only).
The Black & Decker policy is one of continuous
improvement to their product and as such they
reserve the right to change product specification
without prior notice.
Double insulation
Your product is double insulated. This
means that all external metal parts are
electrically isolated from the power supply.
This is achieved by placing an extra
insulation barrier between the electrical and
mechanical parts. Double insulation means
greater electrical safety and obviates the
necessity of having your product earthed.
Electrical safety (UK only)
Your product should always be switched off at the
mains before disconnecting any plug and socket
connector or extension cables.
Fuse replacement
If your product is supplied with cable, fitted with a
non-re-wireable plug:
•
The plug is fitted with a 13 amp fuse which is
the recommended fuse for your product.
•
Only use replacement fuses which are
approved to BS1362.
•
When changing the fuse in your plug, always
ensure the fuse cover is refitted. If the fuse cover
is missing or damaged do not use the plug.

ENGLISH

Note: Fuses do not give personal protection
against electric shock.
Plug replacement
•
Disconnect the plug from the supply.
•
Cut off the plug and dispose of immediately.
Insertion of a detached plug into a 13 amp
socket outlet may result in electric shock.
•
Only fit BS1363A approved plugs fitted with the
correctly rated fuse.
•
The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see above).
Brown is for "Live" (L) and blue is for "Neutral"
(N).
•
Before replacing the top cover of the mains
plug ensure that the cable restraint is holding the
outer sheath on the cable firmly and that the
two leads are correctly fixed at the terminal screws.
Fit a BS1363A
approved
resilient plug
Connect blue
to N (neutral)
Make sure that the
outer sheath of the
cable is held firmly
by the clamp
Warning! Never connect live or neutral
wires to the earth pin marked "E" or
Note: Do not wire an extension cable directly into
your machine yourself. Instead, take your product
to your nearest Black & Decker authorised repair
agent.
Increased safety can be obtained by having a
qualified electrician install a high sensitivity (30mA)
circuit breaker in the house wiring. If you do not
have such a circuit breaker installed, or you do not
wish to have one installed, then we strongly
recommend that the electrical power to the
machine be supplied through a high sensitivity
residual current device (RCD). The RCD is designed
to provide a high degree of personal protection
against harmful electric current should fault
conditions occur.
Fit the recommended
fuse approved
to BS1362
Connect brown
to L (live)
230 volts AC only
Never use a light
socket
.
9