Chapter 1: Introduction; About This Guide; Setup Overview - Honeywell HX3 User Manual

Chapter 1: Introduction

The HX3 Battery Charger is designed to simultaneously charge six rechargeable Lithium Ion (Li-Ion) battery packs. The time
required for charging is dependent upon the battery pack temperature and conditions.
The battery charger should be located in an area where it:
Is well ventilated.
l
Is not in high traffic areas.
l
Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
l
Has enough clearance to allow easy access to the power port on the back of the device.
l
Is protected from rain, dust, direct sunlight or inclement weather.
l
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell batteries sealed inside the mobile device, if any.

About this Guide

This HX3 Battery Charger User's Guide is intended to familiarize the user with the safety and operating instructions necessary
to use the HX3 Battery Charger (Model HX2A310CHGR6US, HX2A311CHGR6WW) to charge rechargeable lithium-ion
battery packs (HX2A301BATTSTD, HX2A302BATTEXT) .
This guide should be readily available to all users and maintenance personnel using this battery charger.

Setup Overview

The following instructions are abbreviated and intended to give an overview of the process to be followed.
1. Assemble the power supply.
2. Connect the power supply to the charger.
3. Insert a battery into a charging bay.
4. When the battery is charging, the setup process is complete.
Note: Store the charger and batteries when not in use in a cool, dry, protected place.
Note: Batteries used by the HX3 body worn Voice device are charged, recharged and analyzed using the HX2 labeled
battery charger.
Please refer to the HX3 User's Guide for instruction when connecting and removing batteries.
1-1