Unpacking; Removing Protective Packing Materials; Installing The Td Cartridge; Loading Paper - Sharp AL-2051 Service Manual

4. Unpacking

Be sure to hold the handles on both sides of the unit to unpack the
unit and carry it to the installation location.
5. Removing protective packing
materials
1) Remove all pieces of tape shown in the illustration below.
Then open the RSPF and remove protective materials. After
that, take out the bag containing the TD cartridge.

6. Installing the TD cartridge

1) Open the multi-bypass tray, and then open the side cover.
2) Remove the CAUTION tape from the front cover and remove
the two protective pins from the fusing unit by pulling the
strings upward one at a time.
CAUTION tape
3) Push gently on both sides of the front cover to open the cover.
4) Remove the TD cartridge from the bag. Remove the protective
5) Gently insert the TD cartridge until it locks in place while push-
6) Close the front cover and then the side cover by pressing the
Caution: When closing the covers, be sure to close the front cover

7. Loading paper

1) Raise the handle of the paper tray and pull the paper tray out
Protective pins
2) Remove the pressure plate lock. Rotate the pressure plate
AL-2051 UNPACKING AND INSTALLATION 5 - 2
paper. Hold the cartridge on both sides and shake it horizon-
tally four or five times. Hold the tab of the protective cover and
pull the tab to your side to remove the cover.
4 or 5 times
ing the lock release button.
Lock release button
round projections near the side cover open button.
securely and then close the side cover. If the covers are
closed in the wrong order, the covers may be damaged.
until it stops.
lock in the direction of the arrow to remove it while pressing
down the pressure plate of the paper tray.