Honda ACCORD Owner's Manual page 347

Replacing a Rear License Plate
Bulb
TRIM CLIPS
1. Open the trunk.
2. 6-cylinder models
Remove the six trim clips from the
trunk lid trim by carefully prying
them using a small, flat-tipped
screwdriver.
Carefully bend back the corner of
the trunk lid trim to expose the
bulbs.
3. Remove the socket from the light
assembly by squeezing the tabs on
both sides of the socket.
4. Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
5. Turn on the parking lights and
check that the new bulb is
working.
6. Reinstall the socket back in place
by pushing it in until it latches.
7. 6-cylinder models
Reinstall the trunk lid trim. Make
sure it is installed under the edge
of the trunk lid seal.
8. Put each trim clip in the hole on
the trunk lid trim and push on the
center until it locks (the center is
flush with the head).
Maintenance
Lights
349