Honda ACCORD Owner's Manual page 317

BOLT CONNECTOR
IGNITION COIL
2. Clean up any dirt and oil that have
collected around the ignition coils.
3. Use a wrench to remove the bolt
holding the ignition coil. Pull the
ignition coil up slightly.
4. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
LOCK TAB
5. Remove the ignition coil.
6. Remove the spark plug with
a five-eighths inch (16 mm) spark
plug socket.
7. Put the new spark plug into the
socket, then screw it into the hole.
Screw it in by hand so you do not
crossthread it.
Spark Plugs (4-cylinder Models)
8. Torque the spark plug. (If you do
not have a torque wrench, tighten
the spark plug two-thirds of a turn
after it contacts the cylinder head.)
Tightening torque:
13 lbf·ft (18 N·m , 1.8 kgf·m)
CONTINUED
319
Maintenance