Dominion PX
Quick Setup Guide
Thank you for purchasing the Dominion PX intelligent power distribution unit (PDU). The intended use of the Raritan Dominion PX is
distribution of power to information technology equipment such as computers and communication equipment where such equipment is
typically mounted in an equipment rack located in an information technology equipment room.
This Quick Setup Guide explains how to install and configure the Dominion PX. For additional information on any aspect of Dominion
PX, see the accompanying Dominion PX User Guide, which can be downloaded from the Firmware and Documentation section
(http://www.raritan.com/support/firmware-and-documentation/) of Raritan's website. OR you can access the product's online help in the
Product Online Help section (http://www.raritan.com/support/online-help/). For more detailed information on this release, see the latest
release notes, also available from the Firmware and Documentation section.
Unpacking the Dominion PX
Dominion PX comes in Zero U, 1U, and 2U sizes. The following
describes the equipment shipped with each size. Unpack the
components. If any pieces are missing or damaged, report this
to Raritan Technical Support at tech@raritan.com.
Zero U Size
Dominion PX device
Mounting screws, brackets and/or buttons
A null-modem cable with DB9 connectors on both ends
(Raritan number: 254-01-0006-00) (optional)
Cable retention clips for the inlet (for some models only)
and/or outlets
1U and 2U Size
Dominion PX device
1U or 2U bracket pack and screws
A null-modem cable with DB9 connectors on both ends
(Raritan number: 254-01-0006-00) (optional)
Cable retention clips for the inlet (for some models only)
QS Rule
Before You Begin
1. Prepare the installation site. Make sure the installation area
is clean and not exposed to extreme temperatures or
humidity. Allow sufficient space around the Dominion PX
for cabling and outlet connections. Safety instructions are
provided in the Dominion PX User Guide.
2. Fill out the Equipment Setup Worksheet found in the
Dominion PX User Guide. Record the model, serial
Dominion PX Quick Setup Guide
QSG-DPX2-0F-v2.2-E 255-80-6099-00 RoHS
number, and use of each IT device connected to the PDU's
power outlets.
QS Rule
Mounting the Dominion PX
Use one of the mounting methods to install your Dominion PX
device as appropriate.
Circuit Breaker Orientation Limitation
Usually a PDU can be mounted in any orientation. However,
when mounting a PDU with circuit breakers, you must obey
these rules:
Circuit breakers CANNOT face down. For example, do not
horizontally mount a Zero U PDU with circuit breakers on
ceiling.
If a rack is subject to shock in environments such as boats
or airplanes, the PDU CANNOT be mounted upside down.
If installed upside down, shock stress reduces the trip point
by 10%.
Note: If normally the line cord is down, upside down means
the line cord is up.
Mounting 1U or 2U Models
Using the appropriate brackets and tools, fasten the 1U or 2U
Dominion PX device to the rack or cabinet. If your PDU has
circuit breakers implemented, read
Orientation Limitation
(on page 1) before mounting it.
Circuit Breaker
1