Video Setup Menu; Video Input; Sound Effect - Sony IPELA PCS-XG100 Operating Instructions Manual

Wide and Clear: Select this for a wider
pickup range than "Balance". The
quality of the picked up sound will be
clearer.
Manual: Select this to specify "Mic Noise
Reduction" and "Mic AGC" manually.
Mic Noise Reduction
This is only available when "Adaptive Voice
Pickup and Sound" is set to "Manual" and
allows you to set mic noise reduction.
You can select from "High", "Mid", and
"Low". When you select "High", noise
reduction is increased to produce a clearer
sound quality. When you select "Low",
noise reduction is reduced to produce a more
natural sound quality.
Mic AGC
This is only available when "Adaptive Voice
Pickup and Sound" is set to "Manual" and
allows you to adjust the mic gain
automatically.
You can select from "High", "Mid", and
"Low". When you select "High", the sound
pickup range widens. When you select
"Low", the sound pickup range emphasizes
closeness.
Audio3

Sound Effect

Beep Sound
Allows you to select the volume of the beep
that sounds each time you press a button on
the Remote Commander from among
"Loud", "Medium" and "Quiet". You can
also select "Off" for the beep not to sound.
Sound Effect
Allows you to select the volume of output
sound when the system starts, or when
connection starts or is disconnected from
among "Loud", "Medium" and "Quiet".
You can also select "Off" for the sound not
to be output.
Dial Tone
Allows you to select the volume of a ring-
back and busy tones when you are dialing
from among "Loud", "Medium" and
"Quiet". You can also select "Off" for the
ring-back and busy tones not to be output.
Ringer Tone
Allows you to select the volume of a ring
tone when you receive a call from among
"Loud", "Medium" and "Quiet". You can
also select "Off" for the ring tone not to be
output.

Video Setup Menu

The Video setup menu is used to set up video
input/output.
Video1
Basic Setup

Video Input

Allows you to select the video input.
Camera: Selects the camera picture from
the camera connected to the CAMERA
connector.
DVI-I 1: Selects the video signal from the
external equipment connected to the
DVI-I 1 IN connector.
DVI-I 2: Selects the video signal from the
external equipment connected to the
DVI-I 2 (PC) IN connector.
HDMI: Selects the video signal from the
external equipment connected to the
HDMI IN connector.
Note
The "HDMI" setting is not available on the
PCS-XG77/XG77S.
Presentation Screen
Allows you to select the display pattern of
the presentation screen.
The "Presentation Screen" settings are
enabled when "H.239" is disabled during the
communication.
Configure this when conducting
presentations with terminals that do not
support H.239.
Full Screen: Sends the computer picture,
etc. from the external equipment
connected to the DVI-I 1 IN connector
in full screen mode.
Monitor Output
Allows you to select the video signal output
from the Communication System.
Registering Local Information
75