Door Latch & Switch Holder Assembly - Maytag JET CLEAN II JDB1100AW Service Manual

Service and Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Door Latch & Switch Holder Assembly
Two Door Switches are used in the Latch Assembly. Both
switches are normally CLOSED and will open only when
engaged by the Door Latch mechanism. Each switch is
in series with respect to L1 and neutral line operations.
Failure of either or both switches will result in rendering
the Dishwasher inoperative.
Door Switches require no field adjustment.
NOTE:
©2004 Maytag Appliances Company
!
WARNING
Removal
1. Disconnect power to the machine.
2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).
3. Lift Door Latch Assembly out.
Switch Removal
1. Disconnect power to the machine.
2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).
3. Remove Door Latch and Switch Holder Assembly.
4. Depress locking tabs and lift switch from holder.
16022783 Rev. 0 32