Bluetooth; Usb And Network - Yamaha RX-V779 Owner's Manual

Bluetooth

Problem
A Bluetooth connection cannot be established.
No sound is produced, or the sound is
interrupted during playback.

USB and network

Problem
The unit does not detect the USB device.
Folders and files in the USB device cannot be
viewed.
The network feature does not function.
The unit cannot connect to the Internet via a
wireless router (access point).
Cause
Bluetooth
The function of the unit is disabled.
Bluetooth
Another device is already connected to the unit.
Bluetooth
The unit and the device are too far apart.
There is a device (such as microwave oven and wireless LAN) that
outputs signals in the 2.4 GHz frequency band nearby.
The Bluetooth device does not support A2DP.
The connection information registered on the
not working for some reason.
The volume of the Bluetooth device is set too low.
Bluetooth
The device is not set to send audio signals to the unit.
Bluetooth
The connection has been terminated.
The unit and the Bluetooth device are too far apart.
There is a device (such as microwave oven and wireless LAN) that
outputs signals in the 2.4 GHz frequency band nearby.
Cause
The USB device is not connected to the USB jack securely.
The file system of the USB device is not FAT16 or FAT32.
The data in the USB device is protected by the encryption.
The network parameters (IP address) have not been obtained
properly.
The wireless router (access point) is turned off.
The unit and the wireless router (access point) are too far apart.
There is an obstacle between the unit and the wireless router
(access point).
En
Remedy
Bluetooth
Enable the
Terminate the current
(p.66).
Bluetooth
Move the
Move the unit away from those devices.
Use a Bluetooth device that supports A2DP.
Bluetooth
device is Delete the connection information on the
connection between the
Turn up the volume of the
Switch the audio output of the
Establish a Bluetooth
(p.66).
Move the Bluetooth
Move the unit away from those devices.
Remedy
Turn off the unit, reconnect your USB device, and turn the unit on again.
Use a USB device with FAT16 or FAT32 format.
Use a USB device without an encryption function.
Enable the DHCP server function on your router and set "DHCP" in the "Setup"
menu to "On" on the unit (p.111). If you want to configure the network parameters
manually, check that you are using an IP address which is not used by other
network devices in your network (p.111).
Turn on the wireless router.
Place the unit and the wireless router (access point) closer to each other.
Move the unit and the wireless router (access point) in a location where there are
no obstacles between them.
130
function (p.113).
Bluetooth connection and then establish a new connection
device closer to the unit.
Bluetooth
device, and then establish a
Bluetooth device and the unit again (p.66).
Bluetooth device.
Bluetooth
device to the unit.
connection between the Bluetooth device and the unit again
device closer to the unit.