Alarm Input - Samsung SPE-400 User Manual

Alarm input

You can set the alarm input type, activation time, and operation mode.
1. From the Setup menu, select the
<Event ( )> tab.
2. Click <Event setup>.
3. Select <Alarm input> from <Event
action setup>.
4. Set whether or not to <Enable>.
5. Specify an input device.
 Type
- Normal open : It is normally open,
but if it is closed, an alarm will be
triggered.
- Normal close : It is normally closed,
but if it is open, an alarm will be
triggered.
6. Specify the <Activation time>.
 Always : Always check if an alarm occurs. It activates in operated mode when the
alarm occurs.

If set to <Always>, the activation time cannot be changed.
 Only scheduled time : Check if an alarm occurs at a specified day of the week for
a specified time period. It activates in operated mode when the alarm occurs.
 [Clear (
)] : Reset all settings.
7. Specify an operation that will perform if an alarm occurs.
 FTP : Specify the use of FTP transfer in the alarm input setup.
 E-mail : Specify the use of email transfer in the alarm input setup.
 Record : Specify the use of recording in the alarm input setup.
 Alarm output : Select whether to set the alarm output if an alarm is incoming, and
specify the alarm output time.
 Goto preset : Moves to the specified preset location when setting the alarm input.

Only if the camera pan/tilt receiver is installed, Goto preset is available.
8. When done, click [Apply ( )].
English _71