Yamaha YSP-3000 Service Manual page 19

6. Press the [Refer...] button. And select the firmware
name. (Fig. 3)
* The ID code and MCU type are
loaded when the file is se-
lected. (Fig. 3)
Press the [OK] bottom. (Fig. 3)
Press this button to open
the window
7. Press the [Setting] button and set the baud rate. (Fig. 4)
8. Press the [E.P.R.] button, the screen appears as shown
below. (Fig. 5)
Press the [OK] button and start writing. (Fig. 5)
Fig. 3
Select 115200bps or below for the baud rate.
* Reduce the baud rate if a transmission error occurs fre-
quently.
Fig. 4
Writing being executed.
Fig. 5
YSP-3000/YSP-30D/HTY-7030
19