Siemens Landis & Staefa REV11 Series Operating Instructions

Operating instructions
REV11... - the temperature controller that allows you to set the ideal room temperature at the
time you want. There are two switching patterns available that can be set to suit your specific
needs. You can either rely on the factory settings or make settings tailored to your personal
needs.
Display
Heating on
Normal temperature
Replace batteries
Economy temperature
Remote operation active
Standby
(if connected)
Room temperature
(measured)
Time of day
Settings
A1 A2 A3 A4
B1 B2
Time of day
Switching times
A1...A4
A1 A2 A3 A4
1.5V 'AA'
Switching times
1.5V 'AA'
B1...B2
B1 B2
Normal
temperature
Economy
Setting slider
temperature
Operating
Auto Changing the setting values
position
Run
Commissioning with quick startup
The controller is supplied with factory-set switching patterns, switching times and
temperatures. To commission it, proceed as follows:
Remove the black transit tabs from the two batteries. Check to see if the battery
1.5V 'AA'
1.5V 'AA' holder is in its correct position. The controller switches itself on.
Move the setting slider to the time position.
Press buttons to set the correct time of day.
Move the setting slider back to position on the right, because only that position
Auto
allows you to close the cover.
Run
Select the required operating mode with the operating mode selector (e.g.
A
Fold up the operating instructions again, place them back into the cover and close the cover
again.
Landis & Staefa REV11...
Operation
Warmer/colder setting
valid up to the next
switching point
(increments of 0.2 ºC,
± 4 ºC max.)
Change
between normal and
economy mode up to the
°C
next switching point
Operating mode
selector
24-hour mode A
Auto
with 2 heating periods
Run A
24-hour mode B
B
with 1 heating period
Continuous
normal temperature
Continuous
economy temperature
Standby
with frost protection
2222Z11E
Do you want to use automatic
operation?
If that is the case, set the operating
mode selector to one of the
following positions:
You use the 24-hour setting A with
A
two heating periods.
You use the 24-hour setting B with
B
one heating period.
Do you require continuous normal
temperature?
Move the operating mode selector
to «Normal temperature». This
ensures continuous heating to the
normal temperature. The display
shows .
Do you require continuous economy
temperature?
Move the operating mode selector
to «Economy temperature». This
ensures continuous heating to the
economy temperature. The display
shows .
Do you require continuous standby
with frost protection?
Move the operating mode selector
to «Standby». In that case, heating
is provided only when the room
temperature falls below the preset
frost protection limit (5 °C). The
display shows .
Do you feel too warm or too cold?
By pressing these buttons, you
°C
increase or decrease the actual
room temperature in increments of
0.2 °C by a maximum of ± 4°C. The
display first shows the newly
selected temperature and then the
actual value again. These
changes are valid only up to the
next switching point. If, as a
A
).
result of the factory settings, you
always feel either too warm or too
cold, you should readjust the
temperature or to suit your
needs .