Figure 2.3 Front View Of The Mcp; Table 2.4 Ports And Leds Of The Mcp - Samsung OfficeServ 7200 General Description Manual

OfficeServ 7200 General Description Guide
Front View
The components on the front panel of the MCP have the following functions:
Ports & LEDs
LINK1~LINK3
MISC1~MISC2
SmartMedia
LAN
SIO
RST
RUN LED
LAN LED
SM LED
LCP LED
© Samsung Business Communications
LINK 1 LINK 3 MISC1
LINK 2 MISC2

Figure 2.3 Front View of the MCP

Table 2.4 Ports and LEDs of the MCP

Ports that connect the MCP with the LCP.
Ports that connect external music sources, paging device, loud bell, common
bell, or door bell.
Port for installing NAND-type flash memory.
Port for establishing the 10Base-T/100Base-Tx Ethernet connection.
UART port (for tests).
Button for resetting the MCP module.
This LED indicates the status of the MCP.
- Off : Power is not connected.
- On : Booting.
- Blink : The program is operating correctly.
This LED indicates the status of the connection to LAN.
- Off : MCP is not connected to LAN.
- On : MCP is connected LAN.
- Blink : MCP is transmitting or receiving data through LAN port.
This LED indicates the status of SmartMedia access.
- Off : The SmartMedia is not installed.
- On : The SmartMedia is installed but is not accessed.
- Blink : The SmartMedia is installed and is being accessed.
This LED indicates the status of signalling message processing.
- Off : There is no message exchange between MCP and LCP.
- On : Messages are being sent/received to/from the LCP.
CHAPTER 2. OfficeServ 7200 Hardware
LAN
Smart Media
SIO
Function
RUN LAN
SM LCP
RST
MCP
Page 2-7