Fip-1.P3 Solid Black - Dell 2135cn Service Manual

FIP-1.P3 Solid black

Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode
1
Does the error occur only during copying?
Checking the original setting
2
Is the original placed correctly?
Checking the PWBA CONT AIO installation
Reseat the PWBA CONT AIO. (Removal 24/Replacement
3
36)
Does the error still occur when copying?
Checking after replacing the PWBA CONT AIO
Replace the PWBA CONT AIO. (Removal 24/Replacement
4
36)
Does the error still occur when copying?
Checking the solid black.
5 Print the contamination check page.
Is the image printed correctly?
Checking the Toner Type
6
Is the Dell Toner seated?
Checking the printing
7 Is the image printed correctly?
Checked by [Test Print] - [Test Pattern 600] in diagnosis.
Checking the test printing
Is the image printed correctly?
8
Checked by printing the [TestPat (IOT)] in [Test Print] in
printer of diagnosis.
Checking the Grid2.
Print the Grid2 page.
9
Is the solid color printed?
Checked by [Test Print] - [Grid2] in diagnosis.
Version 3 2008.06.13
Trouble substance
The entire paper is printed jet-black.
Possible causative parts
- ROS ASSY (PL4.1.1)
- PWBA HVPS (PL4.1.19)
- PHD UNIT (PL4.1.21)
- PWBA CONT AIO (PL10.6.6)
- PWBA MCU (PL10.7.7)
- IIT ASSY SUB (PL10.9.2)
Check
1 - 371
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 5.
Set the original
Go to step 3.
correctly.
Go to step 4. End of work.
Replace the IIT
ASSY SUB.
End of work.
(Removal 59/
Replacement 2)
Printing data is
incorrect, then
check the printing
Go to step 6.
data which the
problem
generated.
Change the Toner
Go to step 7. Type setting to
Non-Dell Toner.
Go to step 8. Go to step 9.
Replace the
PWBA CONT
AIO. (Refer to Go to step 9.
Removal 24/
Replacement 36.)
Replace the toner
cartridge of the
Go to step 10.
color by which
Solid was printed.
No