Bosch DCN Next Generation Installation And Operation Manual page 200

200 en | Configuration
NOTICE!
Do not connect an audio input to more than one bundle channel (in the same or one of the
other receiver bundles). When you connect an audio input to more than one bundle channel,
the system can operate incorrectly.
6.
7.
Transmitter bundles
Each transmitter bundle can have 8 bundle channels. To the bundle channels of a transmitter
bundle, you can connect the audio outputs of the cobranet interface. Thus, the audio outputs
take audio signals from the optical network and send them to the CobraNet network.
Do as follows to configure a transmitter bundle of the cobranet interface:
1.
2.
Bundle number
0
1 to 255
256 to 65279
Table 7.22 Bundle numbers
NOTICE!
When the CobraNet network must send the transmitter bundle to one other device on the
CobraNet network, make sure that the transmitter bundle is a unicast bundle.
3.
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Enter the values of the other parameters (for example, the bundle priority) of the receiver
bundle (refer to the online help of the CNConfig).
Repeat steps 4 to 6 for the other bundle channels in the receiver bundle.
Go to the Advanced Configuration window of CNConfig.
In the Bundle Number field of the transmitter bundle, enter the number of the bundle
that the cobranet interface sends to the CobraNet network (refer to the table in the on-
line help of the CNConfig).
Description
Bundle not in use.
Multicast bundle
Unicast bundle
Double-click the first bundle channel (Ch 1) with the left mouse button. CNConfig shows
a Tx Advanced Configuration window. With the Tx Advanced Configuration window, you
can change the audio outputs that are connected to the bundle channels.
Installation and Operation manual
Conference System
Bosch Security Systems B.V.