1-4. Opening and closing the windows
■
When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot
be closed, close all the doors and perform the following operations using the
power window switch on the relevant door.
Vehicles without a smart entry & start system: After stopping the
STEP
1
vehicle, the engine switch is turned to the "ON" position.
Vehicles with a smart entry & start system: After stopping the vehi-
cle, the "ENGINE START STOP" switch is turned to IGNITION ON
mode.
STEP
2
Hold the power window switch in the one-touch closing position two
consecutive times.
STEP
3
Hold the power window switch in the one-touch closing position
once again and continue holding for 1 second or more after the win-
dow closes completely.
If you push the power window switch to the opening position while the win-
dow is moving, start again from the beginning. If the window continues to
close but then re-open slightly even after performing the above procedure
correctly, have the vehicle inspected by your Toyota dealer.
CAUTION
■
Closing the windows
Observe the following precautions.
Failure to do so may result in death or serious injury.
●
Check to make sure that all passengers do not have any part of their body
in a position where it could be caught when a window is being operated.
●
Do not allow children to operate the power windows.
Closing a power window on someone can cause serious injury, and in
some instances, even death.
■
Jam protection function
●
Never use any part of your body to intentionally activate the jam protection
function.
●
The jam protection function may not work if something gets caught just
before the window fully closes.
68