k a
HANDLEBAR AND STEERING
EAS00673
INSTALLING THE HANDLEBAR
1. Stand the scooter on a level surface.
s WARNING
s
Securely support the scooter so that there
is no danger of it falling over.
2. Install:
• handlebar
NOTE:
Align the slot k a on the steering with the pin on
the handlebar.
3. Tighten:
• handlebar securing nut
4. Install:
• right handlebar switch
• throttle cable
• throttle grip
NOTE:
Lubricate the inside of the throttle grip with a
thin coat of lithium-soap-based grease and
install it onto the handlebar.
NOTE:
• Align the projection on the right handlebar
s WARNING
s
Make sure the throttle grip operates smo-
othly.
5. Fasten:
• wire harness
6. Adjust:
• throttle cable free play
7-28
42.5 Nm (4.25 m • kg)
switch with the hole on the handlebar.
(fixed to steering head with a strap
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" in chapter 3.
Throttle cable free play (at the
flange of the throttle grip)
2 ~ 5 mm
CHAS
)