Cvbs; Y/C; Monitor Streaming Connection (Hybrid Version) - Bosch Divar 700 Series Installation And Operation Manual

28 en | Hardware setup
4.6.2

CVBS

Connect the unit to CCTV monitors using 75 ohm video coaxial cables with BNC connectors.
The unit provides a 1 Vpp CVBS signal.
If the monitor has a loop-through connection without using the loop-through output, then
select the 75 ohm impedance setting on the monitor. If the monitor's loop-through output is
connected to an additional device, the device's termination is set to 75 ohm and the monitor's
termination is set to high impedance. (This is not necessary on devices with automatic
termination.)
Specifications
Output signal: Composite video 1Vpp, 75 ohm, Sync. 0.3Vpp ±10%
Resolution: 704 x 576 PAL, 704 X 480 NTSC
Connector type: BNC
CVBS
Figure 4.9 CVBS monitor connectors (hybrid version)
4.6.3

Y/C

Connect the unit to a CCTV monitor with Y/C input, using a standard Y/C connection cable.
Y/C
Figure 4.10 Y/C monitor connectors (hybrid version)
4.7

Monitor streaming connection (hybrid version)

To connect a monitor in a remote streaming configuration, connect the CVBS monitor output
to a video input. Then connect the monitor to the corresponding loop-through connector.
Figure 4.11 Typical monitor streaming connection (hybrid version)
F.01U.246.471 | v3.4 | 2011.06
B
A
B
A
KBD in Ethernet
- | + | G
RS
485
MAL
OUT
VGA
N0 | C | NC KBD out USB USB IR ext
Monitor out
AC
1 2 3 4
Video in
1 2 3 4
Video out
Installation and Operation manual
B B B
Com 1 Com 2
A A A
CVBS Y/C Biphase Alarm I/O
5 6 7 8 9 10
Video in
5 6 7 8 9 10
Video out
A
1 3 5 7 9
L
R
A B 2 4 6 8 10
Audio out Audio in
11 12 13 14 15 16
Video in
11 12 13 14 15 16
Video out
B
Bosch Security Systems
Divar 700 Series
11 13 15
12 14 16