Panasonic DBS-576 Technical Manual page 300

FF2: Trunk Programming (Analog E&M Tie)
Introduction
DTMF Conversion (Inbound Calls)
(all CPCs) - Version 1.0 or higher
Set whether the E&M tie trunk will switch from dial-pulse to DTMF signaling
0
after the extension user answers an incoming call.
System
Configuration
FF1
System
FF2
Trunks
Notes:
FF3
Related Programming:
Extensions
DTMF/Dial Pulse Dialing (pg. 2-46)
FF4
FF-/Soft Keys
Indirect LCR
FF5
(all CPCs) - Version 1.0 or higher
(U.K. use only) Enable/Disable the Indirect Least Cost Routing (LCR) function
Groups
on the E&M tie trunk.
FF6
TRS/ARS
BSSC: E&M Tie Trunk Position
FF7
Applications
Notes:
FF8
Indirect LCR: System will send a pre-assigned code (set in the ARS Dial Conversion Tables) when an
Maintenance
extension seizes the trunk to make an outgoing call. This feature is used in the U.K. for sending a
system identification PIN number to the CO.
U.S.A.: Do not enable this address for MCO access code routing (eg., dialing "9" to get an outside line).
Instead, use ARS tables (see FF6) so the system can distinguish intercom calls from outgoing calls.
Appendix A
Appendix B
Page 2-52
FF2 0 BSSC
BSSC: E&M Tie Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2 0 BSSC 02 00 Hold (0 or 1) Hold
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
DBS 576 (USA) issued 05/20/98
02 16 Hold (0 or 1) Hold
0=Do not switch to DTMF signaling.
1=Switch to DTMF signaling after the
extension user answers. (default)
02 17 Hold (0 or 1) Hold
0=Disable Indirect LCR. (default)
1=Enable Indirect LCR.
Section 400-Programming
$ 
$7 !(0 
$ %
 ' 5
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B