General System Configuration
Setting Management Access Controls
N o t e
5-12
CLI: Configuring Management Controls
CLI Commands Used in This Section
Command Syntax
[no] console
[no] ssh
[no] telnet
show console
show system
The following example shows how to enter management configuration con-
text and control access to the Access Point device.
This example shows how to disable the console access to this device using
the no ssh command and display the current status of the access routes using
the show console command.
Enter management commands, one per line.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# no console
ProCurve Access Point 530(config)# show console
------------------------------------------------------------
CLI Access:
Serial Interface
Telnet Interface
SSH Interface
CLI Confirmation Dialogs
Web Access:
HTTP Interface
SSL Interface
ProCurve Access Point 530(config)#
CLI Reference Page
9-23
9-25
9-24
9-28
9-28
Disabled
Enabled
Enabled
Enabled
Enabled
Enabled