Panasonic WJ-SX550A Operating Instructions Manual page 33

WV-PB5508E Video Input Board
1. Video Output Connector (VIDEO OUT 1, 2)
The video signal connected to the Camera Input Connector (CAMERA IN) is looped through to
this connector with 75 ohms termination.
The camera control signal multiplexed on the video signal has been eliminated at this connec-
tor. When the Power Switch of the Matrix Switcher is turned off no signal is obtained at this con-
nector.
BNC female connectors are available by use of optional WV-CA64 loop through cable.
3
2. Camera Input Connector (CAMERA IN, 1 - 8)
This connector accepts either a colour or B/W composite video signal from the camera.
Also, VD2, to synchronize cameras in vertical timing, and data, to control camera site devices
such as receivers, intelligent cameras, and combination cameras, are multiplexed through this
connector.
Pin No.
5
9
4
8
3
7
2
6
1
VIDEO OUT VIDEO OUT
1 2
1 Not used Not used
2 CH1 CH5
3 Ground (CH1) Ground (CH5)
4 CH2 CH6
5 Ground (CH2) Ground (CH6)
6 CH3 CH7
7 Ground (CH3) Ground (CH7)
8 CH4 CH8
9 Ground (CH4) Ground (CH8)
-30-
INPUT
VIDEO OUT1
q
CAMERA IN
1
2
3
4
w
5
6
7
8
VIDEO OUT2