Bosch Security System Owner's Manual page 47

Working with Multiple Areas
from a Single Command Center
Each of the functions described in the preceding section on Advanced Commands is presented as
though your system includes only one area. If your system includes more than one area, it can be
set up one of two ways by the installing company: (1) Each command center will only have access
to the local area to which it is assigned, or (2) Each command center may access either some or all
areas beyond the one to which it is assigned. This factor is referred to hereafter as command center
scope.
If your command center allows access to areas other than the local area (that is to say, has scope in
other areas), then the command center will limit your access to those areas within the command
center scope and for which your personal passcode has authority.
Given that you have access to areas beyond the local area, the means of accessing the various
system functions depends upon the specific function.
For some functions, the command center allows you to select the area (or point) in which to
perform the function. These "selectable" functions are: DISARM ?, BYPASS A POINT?
,UNBYPASS A POINT? and MASTER ARM AREA ?.
Another group of functions may automatically work in all areas in which you have passcode
authority and which are within the scope of the command center. These are: Turning On Multiple
Areas with a Passcode, Turning Off Multiple Areas with a Passcode, DISARM ALL ?, MASTER
ARM ALL?, VIEW MEMORY?, WALK TEST?, RESET SENSORS ?, ADD PASSCODES ?, FIRE
TEST?, VIEW POINT STATUS? and VIEW AREA STATUS?.
Some functions may be area-specific. To perform these functions, you may first use the MOVE TO
AREA ? function (COMMAND 50) to gain access to the desired area. Once in the desired area you
can perform the functions you wish. Area-specific functions include: PERIMETR INST?,
PERIMETR DELAY ?, PERIMETR PART ?, EXTEND CLOSING ?, WATCH MODE ?, COMMAND
7 ?, COMMAND 9 ? and CHG DISPLAY ?.
A last group of functions don't relate to specific areas and are thus system-wide. These are: SEND
REPORT?, REMOTE PROG ?, CHG TIME/DATE ?, CHG SKEDS ?, DEL PASSCODES ?, CHG
RELAYS ?, CHG PASSCODES ?, PRINT LOG ? and VIEW LOG?.