Brother HL-2600CN Service Manual page 200

Sequence of Replacement
1) Lift the transfer roller 2 lock levers at both sides (right & left) to the arrow
direction A. (Fig.6-25)
2) Holding the lock levers at both sides, pull them upwards to remove the transfer
roller 2.
3) Install a new transfer roller 2 into the printer.
i) Prepare a new transfer roller 2.
ii) Hold the lock levers at both sides and align both ends of the shaft to the slit on
the transfer base.
iii) Push the transfer roller 2 shaft into the slit and place the bearing of the roller
onto the spring. Ensure that the spring is not bent as shown in Fig. 6-25.
iv)Fix the transfer roller 2 by pulling down the lock levers at both sides to the
arrow direction B.
Lock lever
Spring
Proper assembly
Transfer roller 2
Fig.6-24
A
B
Fig.6-25
VI-28
Wrong assembly