Configure Wpa-Personal (Ap Mode) - D-Link AMPLIFI DAP-1525 User Manual

Section 4 - Security

Configure WPA-Personal (AP Mode)

It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the access point (192.168.0.50). Click
on Setup and then click Wireless Settings on the left side.
2. Select Enable WPA/WPA2 Wireless Security (enhanced) from the
Security Mode drop-down menu.
3. Select Auto(TKIP/AES), TKIP, or AES from the Cipher Type drop-
down menu. If you have wireless clients that use both types, use
TKIP/AES.
5. Select either PSK or EAP from the drop-down menu.
6. Enter your Network key in the Network Key section. The key is
entered as a pass-phrase in either ASCII or HEX format. If using
ASCII format the pass-phrase must be between 8-63 characters. If
using HEX format the pass-phrase must be 64 characters. The ASCII or HEX pass-phrase must be the same at both ends of
the wireless connection.
7. Click on Enable to enable the Wi-Fi Protected Setup.
8. Click Save Settings at the top of the window to save your settings.
D-Link DAP-1525 User Manual 66