Installing Procedures - Pioneer PDP-433CMX Technical Manual

[503CMX/503MXE : 433CMX/433MXE]

4.4.3 Installing procedures

Installation instructions are noted below. When installing
the unit, if a screw or other object should drop inside the
plasma display, immediately consult your nearest Pioneer
Service Center. Continuing operation may result in
malfunction.
This device has been designed for installation on the
Pioneer Plasma Display PDP-503CMX/PDP-503MXE and
PDP-433CMX/PDP-433MXE. Installation procedures are
as follows:
Confirm the following before installing this video card:
• Disconnect the plasma display from computer or other
components.
• Disconnect the plasma display's power cord from its
outlet.
Installation Notes:
• When opening the installation cover, take care not to
drop screws or other objects in the opening. Objects
dropped inside the display may cause damage or
malfunction.
• When installing the video card, if the plasma display is
laid with its screen side facing down, the work surface
should be flat and level, and either the packing material,
a blanket, or other soft material should be spread on
the work surface first to protect the screen. Take care
to prevent scratches or other damage to the unit from
tools or other objects. Never rest the display on a surface
in such a way that weight or pressure is placed only on
the screen surface.
• This video card has been designed for exclusive use
with the Pioneer Plasma Display PDP-503CMX/PDP-
503MXE and PDP-433CMX/PDP-433MXE. Do not
attempt unauthorized modifications or alterations since
malfunction or damage may result.
• Take care not to modify or damage the card's internal
devices in any way.
• Before installation, take precautions to eliminate static
electricity on your body. Do not touch the card's circuitry
or devices.
• This device has not been designed to allow reinstallation
or removal; after the card has once been installed on
the plasma display, do not attempt to remove it since
damage may result.
Installation
1 Remove the protective cover over the video card
slot on the plasma display's terminal panel.
Video card: PDA-5002
2 Insert the video card gently and evenly in alignment
with the two rails visible inside the installation port.
Note
Be very careful when inserting the card. Insert straight!
The card or display may be damaged if the card is
inserted crooked or with excessive force.
AUDIO S-VIDEO
INPUT5 INPUT3
DIGITAL RGB
3 After inserting the video card all the way into the
slot, confirm that it is seated securely, then use the
screws removed in step 1 to secure the card in place.
INPUT5
DIGITAL RGB
4 Affix the accessory connector indicator label to the
plasma display, and affix the remote control unit
label to the remote control unit furnished with the
plasma display.
INPUT5
DIGITAL RGB
INPUT5
DIGITAL RGB
Note
Use a soft cloth to gently wipe any dust
from the surface before affixing the label.
Video Card Removal (In principle, removal of the
video card should not be attempted).
1 Remove the two screws holding the video card.
INPUT5
DIGITAL RGB
2 Holding the inside tabs, pull the video card out
straight.
AUDIO S-VIDEO
INPUT5 INPUT3
DIGITAL RGB
AUDIO VIDEO OUTPUT
INPUT4
AUDIO INPUT3 S-VIDEO AUDIO VIDEO OUTPUT
INPUT4
AUDIO S-VIDEO AUDIO VIDEO OUTPUT
INPUT3 INPUT4
INPUT3 INPUT4
AUDIO S-VIDEO AUDIO VIDEO OUTPUT
R L R L
VIDEO OUTPUT
AUDIO INPUT3 S-VIDEO AUDIO INPUT4
AUDIO VIDEO OUTPUT
INPUT4
73