Board - Sony Digital HDVS HDC-900 Maintenance Manual

[Notes|at|installation]
. Tuck the harness of the fan to the back of the separate
plate (2).
. Take out the connection connector to the AT-146 board
from near center of the upper portion.
. Insert the guide pins of the chassis into the holes of the
separate plate (2)
. Be very careful not to catch the fan harness between the
chassis and fan itself when installing the fan block.
Separate plate (2)
Fan block
HDC-900/950 MM
To CN2/AT-146 board
Tuck this
harness inside
Screw
Holes for guide pin
Screws
3-15. Replacing the Components of HKC-T950
3-15-6. RE-202 Board
1. Remove the separate plate (2) block. (Refer to steps 1
to 7 of Section 3-15-5 "IF-845 Board".)
2. Disconnect the connectors (CN3, CN2) of the RE-202

board.

3. Remove the adhesive tapes shown in the figure.
Tapes
(remove)
RE-202 board
4. Remove the four screws, and remove the RE-202
board.
Screws
Screws
5. Install the new RE-202 board in the reverse order of
steps 1 to 4.
Separate plate (2)
block
CN1
CN3
CN2
RE-202 board
Separate plate (2)
3-29 (E)