Forming Before Installation (Hdc-950/930); Positioning Adjustment For Installing The Filter Knobs (Hdc-950/930, Hkc-T950) - Sony Digital HDVS HDC-900 Maintenance Manual

1-5. Notes on Flexible Card Wire

1-6. Positioning Adjustment for Installing the Filter Knobs (HDC-950/930, HKC-T950)

1-5-2. Forming Before Installation (HDC-950/
930)
If using a new flexible card wire, be sure to hand-form it as
shown in the figure before installation.
n
Never fold it back after being formed once.
. MB-882 board CN24 ↔ CN-2018 board CN2
Conducting surface (silver)
Insulating surface (blue)
CN-2018(CN2)
25
43
. MB-882 board CN29 ↔ CN-1951 board CN6
Insulating surface (blue)
CN-1951(CN6)
MB-882(CN29)
Conducting surface
(silver)
30
1-8 (E)
MB-882(CN24)
56
unit : mm
170
unit : mm
1-6. Positioning Adjustment for
Installing the Filter Knobs
(HDC-950/930, HKC-T950)
Installing the filter knobs, be sure to perform the following
adjustment.
1. Remove the inside panel. (Refer to Section 1-4 of
Installation and Maintenance Manual.)
n
If the HKC-T950 is installed, remove the right side
panel of the CCD block adaptor referring to Section
3-15-5.
2. Align the CC filter knob number with the number
(CC) on the filter disk unit and tighten the two set-
screws.
Tightening torque : 20 x 10
3. Rotate the CC filter knob and check that it moves
smoothly.
4. Align the ND filter knob number with the number
(ND) on the filter disk unit and tighten the two set-
screws.
Tightening torque : 20 x 10
5. Rotate the ND filter knob and check that it moves
smoothly.
Setscrews
(WP2 x 3)
Setscrews
(WP2 x 3)
1 B
_2
N.m (2.0 kgf.cm)
_2
N.m (2.0 kgf.cm)
ND
1 CLEAR
2 1/4 ND
1
3 1/8 ND
4 1/16ND
5 1/64ND
CC
A CROSS
B
B CLEAR
C 4300K
D 6300K
E 8000K
Filter disk unit
HDC-900/950 MM