Toro MM-658H-P Operator's Manual page 3

Introduction
This machine is designed to mix mortar, plaster, fireproofing
material, grout, and other small-grained Portland cement
products. A vehicle equipped with an appropriate pintle hitch
or ball hitch can tow the machine.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
safety and operation training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready. Write the numbers in the space provided.
1
1. Model and serial number
location
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety-alert symbol
2
Figure 1
2. Vehicle identification
number (VIN) location
(Figure
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
Tire Information
The DOT tire information is located on the side of each tire.
This information gives load and speed ratings. Replacement
tires should have the same or better ratings.
Note: The various machines in this manual have different
weights; refer to
tires on your machine meet or exceed the weight requirements
of your machine.
G020900
2),
3
Figure 2
Specifications (page 13) to ensure that the