Table of Contents
Advertisement
18
INSTALLATION
3.
Make sure the alignment tabs reengage.
Connect to Notches
4. Reattach the inner door
to the outer door using
the nine screws removed
earlier. See illustration,
Step 1.
5.
Check to verify that the
scoop (wider section) of
the door bowl is situated at
the BOTTOM of the door.
Reinstalling door assembly
1.
Insert the wiring harness terminal into
the terminal cap and wrap the harness
into the harness retainer.
2.
Slide terminal cap onto back of hinge
plate until tabs snap into place.
3.
Insert hinge locating pins into the hole
that were previously covered by the
plastic hole cover. Press on the face of
the hinge to snap the other locating
pins into place.
4. Reinstall all four screws removed earlier
- two front screws first, then two side
screws.
x4
Fine Thread
Verify reversed door operation
1.
Test door for free, smooth swinging
operation and secure latching when
closed.
2.
Verify inner door bowl is in the correct
orientation with the "scoop" at the
bottom.
3.
Plug in washer and close the door. Test
correct door lock operation by starting
a test cycle: lock should engage, and
door should not be able to be opened
until cycle is paused or canceled.
1
3
4
2
Advertisement
Table of Contents
