Table of Contents
Advertisement
Connection of the 75 ohm/300 ohm antenna adaptor
Indoor antenna feeder
Loosen the screws with a screwdriver. Insert the antenna terminals
under the screw heads and tighten the screws firmly.
@ 75 ohm coaxial cable connection (Follow the order of numbers.) (For Europe)
ie
Arrange the coaxial cable as illustrated.
Open the 75 ohm/300 ohm antenna
Cut off red wire and remove it from the
QQ)
(2) adaptor
clip.
Press the claws in the direction of the
arrows with the fingers to release the
lock and pull out the cover.
Remove the
\ //
red wire
Outer shield
(Braid)
Inner
conductor
RG-6 (5C-2V) or RG-59 (3C-2V)
Connect the processed coaxial cable to
(5) Secure the holders A and B.
75 ohm/300 ohm antenna adaptor as
shown below.
Insert into the the slot on the clip.
Wire mesh
U.S.A., Canada - | FM:
100 kHz
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear
and South
75
panel is set to the correct setting that prevails in the area to
American
AM:
10 kHz
which
the
unit
is shipped.
However,
if the
FM
DE-
countries
EMPHASIS/CHANNEL
SPACE setting is not matched to the
Other
FM:
50 kHz
area where the unit is to be used for instance, when you move
,
from area 1 to area 2 or vice versa, desired reception of AM/FM
countries
.
AM:
9 kHz
broadcasts cannot be expected. In this case, change the FM
DE-EMPHASIS/CHANNEL SPACE setting in accordance with
the area corresponding to the table on the left.
The FM DE-EMPHASIS setting is switched over at the same
Area
FM DE-EMPHASIS/CHANNEL
SPACE table
time.
Note:
a aaa tees
DE-EMPHASIS
When changing the setting of the FM DE-EMPHASIS/CHANNEL
5O0kHz
9kHz
50us 4 H
SPACE switch, first disconnect the power cord, then reset the chan-
100kHz
10kHz
= 754s ¥
nel space switch, connect the power cord again, and turn the power
on.
KR-V6020 (En) §
Advertisement
Table of Contents
