Advertisement
en-us_main.book.book Page 9 Friday, February 16, 2024 1:13 PM
If a manometer is not available, turn the gas
supply to the cooktop on and use a liquid leak
detector at all joints and connections to check
for leaks. Tighten all connections, if necessary,
to prevent gas leakage in the cooktop or
supply line.
WARNING
• DO NOT USE A FLAME TO CHECK FOR GAS LEAKS.
• The appliance and its individual shutoff valve
must be disconnected from the gas supply
piping system during any pressure testing of
that system at test pressures in excess of 1/2 psi
(3.5 kPa).
• The appliance must be isolated from the gas
supply piping system by closing its individual
manual shutoff valve during any pressure
testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa).
Flexible Connector Hookup
Gas inlet Manifold
a
Elbow
b
Brass Connector
c
Pressure Regulator
d
Adapter
e
Gas Flow into Cooktop
f
Flex Connector (3 ft. max. in US, 6 ft. max. in
g
Canada)
Adapter
h
Gas Shut-off Valve
i
1/2" or 3/4" Gas Pipe
j
NOTE
• Installer: Inform the consumer of the location of
the gas shut-off valve.
• The gas shut-off valve should be installed in an
accessible location in the gas piping, external to
the appliance, for the purpose of turning on or
shutting off the gas to the appliance.
3. Electrical Connections
Electrical Requirements
This cooktop requires a 120 Volt, 60 Hertz,
properly grounded dedicated circuit protected by
a 15 A or 20 A circuit breaker or time-delay fuse.
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical
Code, NFPA70 or the Canadian Electric Code, CSA
C22.1-02.
Grounding
IMPORTANT: FOR PERSONAL SAFETY, THIS
APPLIANCE MUST BE PROPERLY GROUNDED.
Preferred Method
Ensure proper ground exists before use.
a
The power cord of this appliance should be
equipped with a three-prong (grounding) plug
which mates with a standard three-prong
INSTALLATION
9
Advertisement
