Setting Up The User Data Port; Registering The Number Of Cameras 2-13 (En); Connected To The Video Transmitter - Sony RSE-500 Operating Instructions Manual

Setting Up the USER DATA Port
1
Select 26. RS-232C 2 from the SETTING menu.
The following screen appears.
1 NTERFfiCE:RS-232C
YS-SI00
MQ5TER
<CfiNCEL> <0K>
2
Select the interface using ♦ or ♦, then press
ENTER.
If you are using the YS-SlOO Camera Switcher
(not supplied), select YS-SlOO MASTER.
The following screen appears.
INTERFftCE:YS-SIOO
MASTER
BAUD RATE:1200
2400
4800
l9600"l
1 9200
38400
<CANCEL> <0K>
3
Select the baud rate using ♦ or
then press
ENTER.
4
Select the character bit using or then press
ENTER.
5
Select the parity bit using or #■, then press
ENTER.
You need to register the number of cameras (up to
256) connected to the Video Transmitter to monitor all
of the camera pictures. You cannot switch to all of the
pictures if you don't register the number of cameras.
Registering the Number of
Cameras Connected to the Video
Transmitter
1
Select 8. CAMERA from the SETTING menu.
The following screen appears.
-CAMERA-
NO : iQ]**]
il23456789 B5
<CANCEL> <0K>
2
Select the number of cameras connected to the
Video Transmitter using
-
4
*
or then press
ENTER.
The selected number is entered in the box.
•An asterisk is displayed where nothing is entered.
3
Move the cursor to <OK> using ♦, then press
ENTER.
The setting is registered and the SETTING menu
appears.
S
Select the stop bit using ♦ or
then press
ENTER.
The setting is registered and the SETTING menu
appears.