Bosch AMAX panel 2100 Installation Manual page 9

AMAX panel
MAINS
FAULTS
All icons
The following table shows an overview and a description of the keypad sound icons.
Sound Indicator
Short beep
Short beep, followed by a one-second
beep
Two short beeps
One short beep every minute
One short beep every two seconds
Continued sound
Continuous 0.5 second beep, stops
for 0.5 seconds
Bosch Sicherheitssysteme GmbH
All manuals and user guides at all-guides.com
Fast flash (0.25 seconds lights on/
0.25 seconds lights off)
on
Slow flash (1 second lights on/1
second lights off)
on
off
Flashes
on
Flashing
Installation Manual
Programming mode or code
function mode. AWAY indicator
flashes simultaneously. When
bypass function is performed, only
the STAY indicator flashes.
AC main power is normal.
AC main power supply failed.
System fault or Tamper condition
is present.
System is in normal status.
System fault or tamper condition
must be acknowledged.
System is disarmed.
No communication to the keypad.
Definition
A keypad button has been pressed.
The requested operation is refused. Incorrect
operation signal.
The system accepted the code. The system executed
the requested function.
Fault tone, unacknowledged system failure.
Exit time started.
– Last 10 seconds on exit time
– Keypad fault or tamper sound (fault or tamper
to be acknowledged)
– Keypad alarm sound
– Entry delay time (until alarm ends or system is
disarmed)
– Exit delay time (stops 10 seconds before exit
delay stops)
Short Information | en 9
2015.05 | 06 | F.01U.309.277