Yamaha FLIP-X Series Maintenance Manual page 95

9 Detach the belt.
Remove the belt stay bolts (2 x 2) and
detach the belt from the main unit.
0 Attach a new belt.
q Attach the belt.
1. First, attach the belt from the upper side
of the driven pulley and push it out with
a thin rod.
2. Pass the belt through from the lower side
of the table slider and route the belt
edge under the drive pulley. Then, use a
narrow rod or similar tool to make the
belt edge face upwards.
3. Finally, while making the belt mesh
between the drive pulley and drive
pulley idler, turn the drive pulley so the
belt comes out upwards.
w Attach the belt stays to both ends of
the belt.
e Reattach the belt stay to the table.
Tighten the belt stay mounting bolts
temporarily.
r Adjust the belt tension.
For details, see "2. Adjusting the timing belt
tension (B10/B14/B14H)" in Chapter 3.
Reattach the upper cover.
t
For details, see "1. Adjusting the alignment
(B10/B14/B14H) in Chapter 3.
y Reattach the end cover.
Step 9
Removing the belt stay
53406-AC-00
53407-AC-00
Step 11 Attaching the belt
4
4-21