LG GC-936S Owner's Manual page 17

3. CLEANING AND MAINTENANCE
Removal of oven door
1
Saddle
bracket
2
3
Cleaning of Gas Cooker - Hob Part
• Lift up the pan supports, caps and crowns of hob burners.
• Wipe and clean the back panel with a soapy cloth.
• Wash the caps and crowns of hob burners and rinse them. Do not leave them wet, immediately
dry them with paper cloth.
• After cleaning, make sure that you re-assemble the parts correctly.
• Do not clean any part of the hob with metal sponge. It causes the surface be scratched.
• The pan support top surfaces may be scratched in time due to usage. In this case, these parts
may get rusted and it is not a production fault.
• During cleaning of the hob plate, make sure that no water flows inside the burner cups, as this
may block the injectors.
Burner Caps:
Periodically, enameled pan support, enameled covers, burner heads must be washed with
soapy warm water rinsed and dried. After drying them thoroughly, replace them correctly.
(caution) If burner head and cap are not dried completely and aren't reassembled correctly,
the status of frame can be strange.
To remove the oven door;
• Open the oven door(1).
• Open the saddle bracket (with aid of
screwdriver, tongs etc.) up to end position(2).
• Close the door till it almost reaches to the full
closed position as shown in 3 figure and
remove the door by pulling it towards yourself.
NOTE: To re-assemble the door follow the opposite
Recessed
rules of removal.
form
!
should be positioned properly on the hinge
counterparts as shown on 2 figure.
15
Please pay attention that the recessed forms
rd
nd