Publication no. 201102
5.5 Checking if a motor works
This check is preformed by simply connect an external power supply to the motor.
• Power down the camera and disconnect the motor connector.
• Move the carriage to its center position about 60 cm to the right.
!
WARNING! To apply external voltage to the motor will cause a immediate
reaction. To avoid mechanical damages, use a 12VDC/1A supply.
• Connect the supply to the motor and switch it on for just a few secunds.
• If the motor is OK the carriage should move a bit.
September 2003
34
NIC2-2 · Network ID Camera
Motor
connector
Triacon AB Sweden