Replacing The Sealing Strips - Siemens NIC2-2 Troubleshooting Manual

Publication no. 201102
• When the top cover is on its place, connect the two connectors 'A' and 'B' again.
• Power on the system and verify function.
NOTE! The green LED 'E' indicates 24VDC out.

4.3 Replacing the sealing strips

• Open the top of the camera according to the description at the beginning of chapter 3.
• Remove the upper baffle by loosening (not removing) the two screws (A) at the front and
then pull upwards at the front of the baffle.
• Remove the cover (C) of the optical unit by loosen the screws (B), two at each side. If
the entire exposure unit is removed it must be adjusted after reinstallation, see chapter
4.2. NOTE! The mirror surface should NOT be exposed to any kind of physical contact.
• Remove the sealing strips (D) fixed from below on the cassette cover sheet. Make sure
that the surface is clean from old remains.
• Apply the new sealing strips. We recommend that Loctite 406 glue together with Loctite
770 primer is used.
• Reinstall the cover (C). If necessary, clean carefully the display window and the lens
using a soft piece of rug and alcohol. NOTE! Do not clean the mirror.
• Put the upper baffle in place and tighten the screws (A).
• Close the top of the camera.
• Done.
September 2003 20
NIC2-2 · Network ID Camera
Triacon AB Sweden