Toshiba Satellite 110 Series Maintenance Manual page 40

Procedure 3 Format Check
The HDD is formatted using the low level format program and the MS-DOS FORMAT
program. To format the HDD, start with Check 1 below and perform the other steps as
required.
Check 1 Using the Toshiba MS-DOS system disk, partition the hard disk drive using the
FDISK command. Format the hard disk drive using FORMAT C:/S/U to trans-
fer the system program to the HDD. If the following message appears on the
display, the HDD is formatted.
Format complete
If any other error message appears on the display, refer to the Toshiba MS-DOS
Manual for more information and perform Check 2.
Check 2 Using the Diagnostics Disk, format the HDD with a low level format option.
Refer to Chapter 3, Tests and Diagnostics, for more information about the Diag-
nostics Program.
If the following message appears on the display, the HDD low level format is
complete. Partition and format the HDD using the MS-DOS FORMAT com-
mand.
Format complete
If you cannot format the HDD using the Diagnostics Program, go to Procedure 4.
2-22
110 Series