Table of Contents
Advertisement
Installation
Installing the Software
Installing the Software
Required Patches
Refer to Release Notes for a list of required patches.
Installation overview
The software installation for HP-UX has been divided into four steps.
Steps 1-3 will apply to most users. Step 4 only applies if you are
installing on a Netscape 3.x server.
1. Install the device driver and SwiftAPI.
2. Quick verify process.
3. Install the Netscape plug-in module.
4. Installation procedure for Netscape 4.x servers.
Step 1: Install the device driver and SwiftAPI
This procedure installs the device driver and SwiftAPI from a depot file.
1. Be sure you have installed the HP Praesidium SpeedCard in your
system using the previous instructions.
2. Run the swinstall program.
3. Select the appropriate source depot type (Local CD, Local Tape, Local
Directory, Network Directory).
4. Select the source host name.
5. Select the source depot path. Click the "Source Depot Path" button to
list all.
6. Highlight Praesidium SpeedCard software.
7. Choose "Mark for Install" from the "Actions" menu.
8. Choose "Install" from the "Actions" menu. An analysis window will
pop up.
9. Activate the "OK" button in the "Installation Analysis Window" when
the status field displays a "READY" message.
10. Activate the "Yes" button at the Confirmation Window to confirm that
you want to install the software. "swinstall" loads the fileset, runs the
36
Chapter 3
Advertisement
Table of Contents
