Installation
Installing the hardware and software
connector.
Hinge
Step 12. Align the HSC connector on the HP Praesidium SpeedCard with the
HSC connector in the slot.
If you are installing the SpeedCard in the Expansion I/O card, make sure
the nylon standoffs on the SpeedCard are properly aligned with the
small round holes on the Expansion I/O card. (Note that if you are
installing the SpeedCard in the Core I/O card, the standoffs do not
connect to the Core I/O card.)
Step 13. Press the SpeedCard firmly into place, making sure that the two HSC
connectors are flush with each other. If you are installing the card in the
HSC Expansion I/O card, make sure the nylon standoffs on both sides of
the HSC connector are snapped firmly into place, to properly complete
the card's installation.
Step 14. Use a screwdriver to screw the card into place by screwing in the two
screws on the front of the slot. The following figures show the SpeedCard
30
Standoffs
HSC Connector
Hinge
Chapter 3