Slot Assembly - Sony AXS-R7 Service Manual

2-10.

Slot Assembly

Preparation
1. Remove the docking module. (Refer to
2. Disconnect the battery harness from the RE-340 board. (Refer to
3. Remove the rear case assembly. (Refer to
4. Remove the SW-1706 board. (Refer to
5. Disconnect the RE-IF-power harness from the RE-340 board. (Refer to
from the Connector)")
6. Remove the duct assembly. (Refer to
Procedure
1. Disconnect the two harnesses from the connectors (CN302, CN303) on the RE-340 board.
RE-340 board
Duct
Slot A
Note
When connecting the harnesses, observe the following instructions.
• Connect the harnesses for slots A, B to the following connectors.
Harness for slot A: CN302
Harness for slot B: CN303
• Tuck the harnesses under the duct.
AXS-R7
"2-2. Docking Module")
"2-4. Rear Case
"2-8. SW-1706 Board")
"2-9. Duct Assembly")
Harness
Harness
(from slot B)
(from slot A)
CN303
CN302
Slot B
"2-3. Battery Harness")
Assembly")
"2-6. RE-IF-Power Harness (Disconnecting
2-15