Sw-1706 Board - Sony AXS-R7 Service Manual

2-8.

SW-1706 Board

Preparation
1. Remove the docking module. (Refer to
2. Disconnect the battery harness from the RE-340 board. (Refer to
3. Remove the rear case assembly. (Refer to
Procedure
1. Remove the screw, and then remove the SW-1706 board.
2. Disconnect the two harnesses from the two connectors (CN101, CN203) on the SW-1706 board.
SW-1706 board
Hole
CN203
PSW2 x 5
CN101
Arrangement of the harness
RE-340 board
SW-1706 board
Note
When installing the SW-1706 board, observe the following instructions.
• Align the boss with the hole.
• Twist the harness [A] once in the direction of arrow and arrange it as shown above.
• Pass the harness [B] between the two ribs.
3. Install the removed parts by reversing the steps of removal.
AXS-R7
"2-2. Docking Module")
"2-4. Rear Case
Boss
Harness [B]
Harness [A]
Harness [A]
Ribs Harness [B]
"2-3. Battery Harness")
Assembly")
2-12