Connecting And Configuring The Emulation Module - HP 16600A Series User Manual

1 Make sure the target system is designed to work properly with
2 Install the emulation module in your logic analysis system, if
3 Connect the emulation module to your target system using the
4 Update the firmware of the emulation module, if necessary. (page
5 Verify communication between the emulation module and the
6 Configure the emulation module. (page 146)
7 Test the connection between the emulation module and the
8 Connect a debugger to the emulation module, if applicable. (page
See Also
Chapter 6: Connecting and Configuring the Emulation Module

Connecting and Configuring the Emulation Module

Connecting and Configuring the Emulation
Module
This chapter shows you how to connect the emulation module to the
target system and how to configure the emulation module and target.
Here is a summary of the steps for connecting and configuring the
emulation module:
the emulation module. (page 130)
necessary. (page 134)
If you are connecting to an HP 16600A/700A-series logic analysis
system, use the Setup Assistant to guide you through steps 3-6 (see
page 19). Use this manual for additional information, if desired.
50-pin cable and the TIM or an analysis probe. (page 139)
144)
target. (page 145)
target. (page 157)
173.)
Chapter 8, "Using the Emulator with a Debugger," beginning on page
173 for information on configuration with a debugger, and on
configuring LAN port numbers.
124 Solutions for CPU32