Table of Contents
Advertisement
12 Disassembly and exchange
▶ Only assemble device parts if it is required to carry out the necessary work.
12�1 Preparing for disassembly
▶ Ensure sufficient stability of the hydraulic power unit.
▶ Observe the weight and the position of the center of gravity of the
▶ Do not loosen the fixation of the hydraulic power unit before the stability of the
▶ Prior to disassembly, drain the hydraulic fluid from the hydraulic power unit as
▶ Use the intended eyebolt, see Fig. 3.
▶ Check secure fitting of the eyebolt if the hydraulic power unit is to be
▶ Please note that the hydraulic power unit may be mounted on an optional
▶ To remove the hydraulic power unit from the installation plate, loosen the
Establishing safety:
▶ Always observe applicable instructions for the overall machinery/system.
▶ Unless these instructions provide different information, proceed as follows:
12�2 Disassembly process
▶ For disassembly, carry out the work steps described in chapter 7 "Assembly"
▶ Hydraulic fluid will run out of the hydraulic line system of the hydraulic power
In general, all disassembled parts should be reassembled properly at the
intended position.
hydraulic power unit.
machine is ensured.
described in chapter 11 "Decommissioning".
transported after disassembly.
installation plate, see Fig. 4.
screw. See Fig. 9.
– Carry out decommissioning as described in chapter 11 of these operating
instructions.
– Unauthorized personnel must not be allowed access to the working area.
in reverse order.
unit or hydraulic system even after draining. For this reason, close all outlets of
lines with suitable blanking plugs.
After disassembly, observe the information on safe transport of the product in
chapter 6 "Transport and storage".
Disassembly and exchange | CytroPac
RE 51055-B, Edition 07.2022, Bosch Rexroth AG
67/80
Advertisement
Table of Contents
