Table of Contents
Advertisement
To install the hydraulic power unit, you should proceed as follows:
▶ Set the hydraulic power unit down on even ground and align it so that its
longitudinal and transverse axes are horizontal.
Bosch Rexroth recommends the use of the optionally available mounting kit.
For a complete list of accessories, see data sheet 51055, see chapter 1.2
"Required and amending documentation".
▶ If the mounting kit is not used, ensure that the hydraulic power unit is
secured against falling over and is insulated against vibration, e.g. by means of
a damping mat.
7�2�1 Dimensions of the hydraulic power unit
The dimensions of the hydraulic power unit can be found in data sheet 51055,
see chapter 1.2 "Required and amending documentation".
7�2�2 Fixing the hydraulic power unit in place
Bosch Rexroth offers an optional mounting kit for fixing the hydraulic power unit
in place.
The mounting kit consists of the following components:
• Installation plate
• Hexagon socket head cap screw M6 x 430 mm for fastening the hydraulic power
unit to the installation plate
• Edge protection for clip
• Damping mat
Furthermore, 4 hexagon socket head cap screws are required for fastening the
installation plate to the base, for example M8 x 20 mm. These are not included
in the scope of delivery.
Assembly | CytroPac
RE 51055-B, Edition 07.2022, Bosch Rexroth AG
27/80
Advertisement
Table of Contents
