Examples Of Finished Size Of Booklets (3-Direction Cutting) - Canon Perfect Binder-F1 User Manual

Examples of finished size of booklets (3-direction cutting)

The following table shows examples that the combination of cover and body pages/
slip sheets when 3-direction cutting is done.
The paper sizes inside the wide frame of table are the finished size of the booklets.
2
Body pages/
Slip sheets
*
You may not be able to set some of the types of booklets and paper if the printer does not support them.
NOTE
If the paper size is not registered in the printer, be sure to use it after registering in the
printer as an irregular paper size.
IMPORTANT

The edges of the bound booklets may be folded when binding booklets with covers that
are larger than the body pages if cutting is not done.

Use body pages and slip sheets that are the same size.

The top/bottom cutting range of this machine is 0.52" to 3.11" [13 to 79 mm], and the
foredge cutting range is 0.26" to 1.94" [6.5 to 49.5 mm] (you can also adjust ± 0.04" [± 1
mm] for the top/bottom, and ± 0.02" [± 0.5 mm] for the foredge by finishing size fine
adjustment). If the finished sizes of booklets set on the printer or printer driver go over the
cutting range of this machine, the cutting will not operate correctly. Be sure to adjust the
printer's cutting range within the available value of this machine.
2-10
Paper and Finished Sizes
13" × 19"
9" × 12" LTR
SRA4
A4
LTR
B5
Cover
SRA3 A3
A4
B5
7" × 9"*
11" × 17" B4
7" × 9"
A5