Description - HP MSR 2000 Preparing For Installation

Description

Table 11 LED description
LED
CF card LED
USB console port
LED
Console port LED
System LED (SYS)
Power module LED
(PWR)
PoE power module
LED
MPU status LED
(ACT)
Fan LED (FAN)
Location Status
Steady green
Flashing green
MPU-100
Steady yellow
Off
Off
MPU-100
Steady on
Off
MPU-100
Steady on
Steady green
Fast flashing
(green)
Slow flashing
(green)
MPU-100
Fast flashing
(yellow)
Slow flashing
(yellow)
Steady yellow
Off
Off
MPU-100
Steady green
Steady yellow
Off
MPU-100
Steady green
Steady yellow
Off
MPU-100
Steady green
Off
MPU-100 Steady green
Steady yellow

Description

A CF card is in position and the host has detected the
CF card.
The CF card is performing read and write operations.
Do not remove the CF card at this moment.
The CF card fails to pass the detection.
No CF card is in position or the CF card cannot be
identified.
The USB console port configuration is not used.
The USB console port configuration is in use.
The serial console port configuration is not used.
The serial console port configuration is in use.
The system is performing power-on self test (POST) for
the memory.
The system is starting up.
The system is operating properly.
The system file is lost.
The memory has failed to pass the POST.
The system file does not exist.
A system hardware fault has occurred.
No power module is installed or no power source is
connected.
The power module is operating properly.
The power module is faulty.
No PoE power module is installed or the PoE power
module is faulty.
The PoE power module is operating properly.
The PoE power module is faulty.
The MPU is in standby state.
The MPU is in active state.
The fan is not in position.
The fan is operating properly.
The fan is faulty.
ii