Care And Cleaning - Electrolux E3GS1-13MN Manual

7. CARE AND CLEANING

CAUTION: Before cleaning, wait until the product is cold.
• Clean the product surface with a damp
cloth or non-abrasive sponge.
• Always clean and dry the product
throughly.
• Use only white vinegar for descaling.
• After use, place the steam nozzle on
the steam nozzle hook.
• After winding up the power cord, tie it
with a tie tape.
• Let the steam nozzle cool down com‐
pletely.
• Before pulling out telescopic rod from
the appliance, it is necessary to fully
retract each telescopic rod.
Descaling
This appliance needs to be descaled regularly. For the descaling frequency, check the ta‐
ble below.
Step 1 Remove the water tank from the main unit.
Step 2 Fill the water tank.
Step 3 Shake the water tank gently and till it to drain the water.
Step 4 Pour the mix of 200 ml of water and 200 ml of white vinegar into the water tank,
place it on the base unit, and gently shake the main engine to fill the boiler with
water.
Step 5 Let the appliance stand for about 8 hours.
Step 6 Shake the main engine gently.
Step 7 Turn the calcium removal knob clockwise. Tilt the product and drain the solu‐
tion.
Step 8 Turn the calcium removal knob clockwise.
Step 9 Fill the water tank to its full capacity and load it into the appliance.
Step 10 Repeat the procedure from steps 5-9.
DOs
Storage
DON'Ts
• Avoid aggressive cleaning agents.
• Do not clean the product with abrasive ma‐
terials.
• Do not soak the steam nozzle in water or
other liquids.
• Do not inject water through steam nozzle
hole or calcium removal port.
• Do not lift or carry the appliance by holding
the ironing board or steam pipe.
• Do not bend the steam hose during stor‐
age.
ENGLISH 7