Sony VID-P110 Service Manual page 12

Preparation
Precautions
• Unplug the VID-P110 from the wall outlet when it is
not being used for a long period of time. To
disconnect the cord, pull it out by grasping the plug.
Never pull it out by the cord itself.
• The fluorescent lamps can get hot during operation.
Do not touch the lamps during operation and when
collapsing the VID-P110.
• Clean the cabinet with a soft cloth lightly moistened
with a mild detergent solution. Never use any type of
solvent such as alcohol or benzine, which might
damage the finish.
• Clean the lens with an air spray or soft dry cloth,
taking care not to scratch it.
• When the fluorescent lamps flash or get darkened, the
fluorescent lamps should be replaced with new ones.
In this case, contact your Sony dealer.
Setting Up the Unit
1
Lift up the camera stand while keeping the
UNLOCK lever pressed down.
Camera stand
UNLOCK lever
2
Adjust the camera to the direction shown by the
arrow so that the lens faces downwards.
10
3
Open both arm lights until they fix in place.
Arm light Arm light
4
Connect the power cord to the AC IN connector on
the rear panel.
Connecting the Unit to Other Equipment
Notes on connections
• Before making any connections, turn off the power of
the VID-P110 and the equipment to be connected.
Example of connections to this unit
Front
Microphone
MIC
Rear
AC outlet
AC power cord (not supplied)
AC power cord (supplied)
VIDEO OUT 1
AC OUT (NTSC (phono jack)
model only)
AC IN
VID-P110
(Rear panel)
S VIDEO IN 1 or 2 AUDIO L, R
1 or 2
VIDEO IN
1 or 2
Video
DIN 4-pin cable a)
or
Audio cable
cable
Video
S video
output AUDIO L and
output
Audio output
R OUT
connector
connector
connectors
Video equipment
a) Note
It is recommended that you use the DIN 4-pin cable
when you connect this unit to the equipment with an S
video input or output connector.
• For NTSC model only: Before connecting a device
such as a monitor to the VID-P110 AC OUT
receptacle, check to see if the power consumption is
2.5 A or less. Do not connect any device whose
power consumption is over 2.5 A to the VID-P110.
VID-P110 (Front)
AC inlet
Video input
connector
Color monitor
Video cable
S video input
S VIDEO OUT connector
DIN 4-pin cable a)
or
Projector
Video cable
Video input connector
VIDEO OUT 2
Screen
(BNC type)
Audio cable
Audio Amplifier
input connectors
Speaker
11